Another Skatebiker

Skate Bike – Eric Alley 1985

Got an email yesterday from Eric Alley. It said:

I saw your site regarding the skate bike. I just purchased one off Ebay. Unfortunately, it did not include the brake system. I was wondering if you have any, or if you know of a source for one.

During high school (Walnut High School, California) in 1985, I was given one of these as I raced BMX for a local bike shop. Had to give it back after a few years though. The picture is of me at 17 on halloween at school. The principal actually let me cruise around on it the whole day.

I replied:

Brakes are easy except for the handle. Cable and brake itself are pure old school low end. The challenge is the handle.

On my system I have 2 brakes. When I replaced the wheel I put on one with a coaster brake. Those are easier to find then a wheel without a coaster brake. The challenge is it is hard to lightly apply the brakes. Tend to skid.

The handle connects to the two bars on the bottom of the seat. I live in Canada and my brake cable and wheel assembly are from Canadian Tire.

The handle is going to require some construction. Either build a new base or find a way to connect a piece of handlebar under the seat for the brake to connect to. Here is a picture I took of my brake handle.

Under-seat brake lever

Eric – Looking forward to pictures of your restoration. Be sure to take apart the cranks and clean/grease. The chain is basic old school as are the pedals. The biggest recommendation on parts is family bike store. My skateboard truck and wheels were trash. I wrote several posts on replacing them and the challenge of bushings. Just read previous posts.

Eric sent a few before pix.

Comments are Disabled